All Issue

2020 Vol.30, Issue 4 Preview Page

Original Article

Calculation of Failure Load of V-shaped Rock Notch Using Slip-line Method

Slip-line법을 이용한 V형 암석 노치의 파괴하중 계산

Youn-Kyou Lee1*
이 연규1*
1Professor, Department of Coastal Construction Engineering, Kunsan National University
1군산대학교 건축해양건설융합공학부 교수
* Corresponding Author
31 August 2020. pp. 404-416
PDF XML Citation
Abstract

An analytical procedure for calculating the failure load of a V-shaped rock notch under two-dimensional stress conditions was developed based on the slip-line plastic analysis method. The key idea utilized in the development is the fact that the α-line, one of the slip-lines, extends from the rock notch surface to the horizontal surface outside the notch when the rock around the notch is in the plastic state, and that there exists an invariant which is constant along the α-line. Since the stress boundary condition of the horizontal surface outside the rock notch is known, it is possible to calculate the normal and shear stresses acting on the rock notch surface by solving the invariant equation. The notch failure load exerted by the wedge was calculated using the calculated stress components for the notch surface. Rock notch failure analysis was performed by applying the developed analytical procedure. The analysis results show that the failure load of the rock notch increases with exponential nonlinearity as the angle of the notch and the friction of the notch surface increase. The analytical procedure developed in this study is expected to have applications to the study of fracture initiation in rocks through wedge-shaped notch formation, calculation of bearing capacity of the rock foundation, and stability analysis of rock slopes and circular tunnels.

Keywords
Slip-line method
Rock notch
Plastic analysis
Mohr-Coulomb yield criterion

2차원 응력조건에서 V형 암석노치의 파괴하중을 계산하는 해석적 절차를 slip-line 소성해석법 기반으로 개발하였다. 노치 주변의 암석이 소성상태에 있을 때 slip-line 중 하나인 α선이 암석 노치 면과 노치 외부 수평면을 연결한다는 사실과 α선을 따라서 변하지 않는 불변량이 존재한다는 이론적 사실이 해석적 절차 개발과정에서 핵심 아이디어로 활용되었다. 암석 노치 외부 수평면의 응력 경계조건을 알고 있으므로 불변량 방정식을 풀면 암석 노치 면에 작용하는 수직응력과 전단응력을 계산하는 것이 가능해진다. 노치 면에 작용하는 응력성분 값을 이용하여 쐐기에 의해 노치에 가해지는 파괴하중을 계산하였다. 개발된 해석적 절차를 적용하여 암석 노치파괴 해석을 수행하였다. 암석 노치의 파괴하중은 노치의 각도 및 노치 면의 마찰이 증가함에 따라 지수함수적 비선형성을 가지고 증가하는 특성이 있음을 해석결과는 보여주었다. 이 연구에서 개발한 해석적 절차는 쐐기형 노치 형성을 통한 암석균열 개시조건 연구, 암반기초 지지력 계산, 암반사면 및 원형터널의 안전성 해석 등에 응용될 수 있을 것으로 기대된다.

키워드
Slip-line 해석법
암석 노치
소성해석
Mohr-Coulomb 항복조건식
References
1
Chen, W.-F., 2008, Limit analysis and soil plasticity, J.Ross Publishing Inc.
2
Das, B.M., 1989, Principles of geotechnical engineering (4th Ed.), Boston, PWS Publishing Company.
3
Davis, R.O. and Selvadurai, A.P.S.,2002, Plasticity and Geomechanics, New York, Cambridge University Press.
10.1017/CBO9780511614958
4
Gao, F.-P., Wang, N. and Zhao, B., 2015, A general slip-line solution for the ultimate bearing capacity of a pipeline on drained soils, Ocean Engineering, 104, 405-413.
10.1016/j.oceaneng.2015.05.032
5
Hill, R., 1960, The mathematical theory of plasticity, London, Oxford University Press.
6
Hoek, E., 1983, Strength of jointed rock masses, Geotechnique, 33(3), 187-223.
10.1680/geot.1983.33.3.187
7
Hoek, E., Kaiser, P.K. and Bawden, W.F., 1995, Support of underground excavation in hard rock, A.A. Balkema.
8
Hoffman, J.D., 2001, Numerical methods for engineers and scientists, New York, McGraw-Hill, Inc.
9
Keshavarz, A., Fazeli, A. and Sadeghi, S., 2016, Seismic bearing capacity of strip footings on rock masses using Hoek-Brown criterion, J. Rock Mech. Geotech. Eng., 8, 170-177.
10.1016/j.jrmge.2015.10.003
10
Lee, Y.K., 2015, Estimation of equivalent friction angle and cohesion of near-surface rock mass using the upper-bound solution for bearing capacity of strip footing, Tunnel & Underground Space (J. Korean Soc. Rock Mech.), 25(3), 284-292.
10.7474/TUS.2015.25.3.284
11
Serrano, A. and Olalla, C., 1994, Ultimate bearing capacity of rock masses, Int. J. Rock Mech. Min. Sci., 31(2), 93-106.
10.1016/0148-9062(94)92799-5
12
Serrano, A. and Olalla, C., 2002, Ultimate bearing capacity at the tip of a pile in rock - part 1: theory, Int. J. Rock Mech. Min. Sci., 39, 833-846.
10.1016/S1365-1609(02)00052-7
13
Serrano, A. and Olalla, C. and Jimenez R., 2016, Analytical bearing capacity of strip footings in weightless materials with power-law failure criteria, Int. J. Geomech., 16.
10.1061/(ASCE)GM.1943-5622.0000465
14
Wang, R. and Skirrow, R., 2008, Slip line solution by spreadsheet, Proc. GeoEdmonton'08, 382-388.
15
Yu, H.-S., 2006, Plasticity and Geotechnics, Springer Science+Business Media, LLC.
Information
  • Publisher :Korean Society for Rock Mechanics and Rock Engineering
  • Publisher(Ko) :한국암반공학회
  • Journal Title :Tunnel and Underground Space
  • Journal Title(Ko) :터널과 지하공간
  • Volume : 30
  • No :4
  • Pages :404-416
  • DOI :https://doi.org/10.7474/TUS.2020.30.4.404
Journal Informaiton Tunnel and Underground Space Tunnel and Underground Space
Online Submission
Archives
: Vol.27, 2017 ~
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close